Use a fluted filler to dress up those areas of your design that call for an extra design touch – flanking a cook top or sink, alongside your entertainment unit or as part of an island assembly. We offer fluted fillers with or without a decorative routed rosette. We also offer door pilaster assemblies for wrapping posts or creating unique door column treatments.
Fluted Fillers – With or Without Rosette
- Fluted fillers can be ordered in custom widths from 3″ to 15-15/16″ in all standard specie offerings including MDF.
- Choose from either Tapered or Rounded flutes (see below). If not specified, flutes will be produced using the Tapered design.
- Edge Profile Options: Fluted fillers come standard with a Machine Edge, but can be ordered with a variety of edge profiles including B-2, C-2, LC-2, L-059, L-061, L-149, PRS-2, V-2 and L-686.
- Beveled edge profile selections include the L-991 (45 degree back bevel) and the L-423 (22-1/2 degree back bevel).
- Premium edge profiles include the L-297, L-304 and LC-Inset edge. Upcharge applies.
- Non-fluted or “flat” areas are standard as shown, but can be customized to meet your design needs. Simply specify the flat dimensions desired. Specify “Flats to measure 0” to extend flutes the entire length of filler.
Door Pilaster Post Assembly – 2,3 or 4 Sided – Raised or Flat Panel
- Use these posts to wrap your columns, create island treatments, etc.
- Standard framing widths: 1-1/2″ stiles, 2-5/16″ rails and 2-1/2″ middle rail.
- Posts cannot exceed 12″ x 96″.
- 2-sided and 3-sided pilaster posts are available assembled only.
- Loose side option available only with four sided Pilaster Post; no additional charge. Post will be constructed as an assembled three sided post with the fourth side held in place with loose splines which can be easily removed, then reinserted at the job site.
- During the finishing process it is possible that some finish materials may get on exposed edges. This finishing material should be removed before glue is applied to allow for a proper glue bond.
- Raised (CRP-10) panel minimum width is 5-3/4″
- Flat (TW-10) panel minimum width is 3-3/4″
- Any wood specie (knotty species not available in TW-10)
- Any panel raise or framing bead (1/4″ veneered panel only on TW-10 Pilaster Door)
- Standard edge as shown, no options
- Most door options available (pegs, grooves, etc)
Pilaster Doors – Raised & Flat Panel
- Use these door panels with 1″ framing to wrap posts or create island treatments where normally only a filler would work.
- Raised (CRP-10) panel minimum width is 5-3/4″
- Flat (TW-10) panel minimum width is 3-3/4″
- Any wood specie (knotty species not available in TW-10)
- Any panel raise or framing bead (1/4″ veneered panel only on TW-10 Pilaster Door)
- Machine edge only, no options
- Most door options available (pegs, grooves, etc)
